Self controlled aircraft is a common children’s play equipment, consisting of mechanical, pneumatic, oil/pressure, and electrical systems, and its common faults are mainly concentrated in these aspects. Zhengzhou Aerospace Amusement, a large children’s playground equipment manufacturer, has summarized the following common faults and troubleshooting methods for self controlled aircraft:
Common faults of children’s amusement equipment for self controlled aircraft: 1. There is a jamming phenomenon and abnormal noise when the self controlled aircraft is started
Reason for malfunction: 1. Bearing damage, 2. Insufficient frictional force on the transmission shaft.
Exclusion method: 1. Replace the bearing, 2. Adjust the position of the transmission shaft.
Common faults of children’s amusement equipment in self controlled aircraft include unstable rotation, abnormal noise, and loud noise.
Reason for malfunction: 1. Motor damage, 2. Loose fasteners in the transmission system.
Exclusion methods: 1. Repair and replace the motor, 2. Tighten the connecting bolts.
Common faults of children’s amusement equipment in self controlled aircraft: button failure
Reason for malfunction: Poor or damaged electrical contact.
Exclusion method: Check, repair or replace buttons, and remove debris from each line connection point.
Common Malfunctions of Self Controlled Aircraft Children’s Amusement Equipment 4: Equipment Rotation Cannot Stop
Reason for malfunction: The time timer is damaged.
Exclusion method: Replace or repair the time timer.Common faults of children’s amusement equipment in self controlled aircraft: Fifth, the aircraft cannot take off or ascend properly
Reason for malfunction: 1. Insufficient pressure in the pneumatic system, 2. Time timer not adjusted properly, 3. Electromagnetic valve stuck, 4. Air leakage in the pneumatic system.
Exclusion methods: 1. Adjust the pressure regulating valve to increase the system working pressure, 2. Increase the timer time, 3. Clean or replace the solenoid valve, 4. Check and repair the pneumatic system.
Common faults of children’s amusement equipment in self controlled aircraft: 6. The cylinder is normal, but the air compressor noise is high and the system pressure is insufficient
Reason for malfunction: 1. Damaged air compressor, 2. Blocked air circuit, 3. Damaged gas tank overflow valve, 4. Excessive system leakage.
Exclusion methods: 1. Replace or repair the air compressor, 2. Repair the air circuit components, 3. Repair or replace the overflow valve, 4. Replace the air pressure components or seals.
Common faults of children’s amusement equipment in self controlled aircraft: 7. When the main power switch is closed and the control console control power switch is turned on, the power indicator light does not light up
Reason for malfunction: 1. No power input from the main power supply or power phase loss, 2. Indicator light bulb burned out, 3. Control circuit leakage circuit breaker tripped.
Exclusion methods: 1. Check the power supply, 2. Replace it, 3. Close it again.
Common Malfunctions of Self Controlled Aircraft Children’s Amusement Equipment 8. Pressing the “Start” Button Cannot Operate the Equipment
Reason for malfunction: 1. Press the start button when the indicator light is not on, 2. There is an alarm signal, 3. The “emergency stop” button is pressed but not reset, 4. The “start” button has poor contact or is damaged.
Troubleshooting methods: 1. Wait until the conditions are met and the start button indicator light is on before pressing it again. 2. Eliminate the alarm fault. 3. Rotate the reset “emergency stop” button clockwise. 4. Repair or replace it.
Common faults of children’s amusement equipment in self controlled aircraft 9. No music sound
Reason for malfunction: 1. Damaged music block, 2. Poor circuit contact.
Exclusion methods: 1. Replace the music block, 2. Check the circuit.
If there is an unknown malfunction in the self-control aircraft that requires the support of our technical personnel, please explain the fault phenomenon, and our company will arrange maintenance personnel to rush to the site for inspection as soon as possible.
